1, pay attention not to use oil-based ink, which easily corrosion for the ink system and blocked the printhead. Original ink is the best choice for you. Cannot be used mixed ink.
2, not charged plug printing line, otherwise will causes the damage of the main board.
3, pay attention to the ink head nozzle ,don’t wipe, clean the ink with depilate cloth or good quality paper towels to absorb glue dry, otherwise may lead to blockages in the ink nozzle.
4, the machine must be connected to ground, when the dry air, static problem that nots allow to ignore, when using some lamination and light medium, take electrostatic charge (especially) when into the paper work soon. Electrostatic charge can lead to the machine and the ink head of security is damaged, take the grounding line will be the only way to electrostatic discharge. Because the static power itself is a huge, so when charged the ink head operation, ensure that the hands have discharge (contact grounding metal body or wear in addition to electrostatic bracelet), otherwise easy to cause the ink head damage of individual ink.
Grounding requirements and methods;
(1) wire should be mechanically strong single strands of copper wire or scratched lines.
(2) should not be shared with ground buildings lightning rod.
(3) a ground wire and machine, in addition, the location of the ground wire to the ground 1.5 meters or deeper, with surrounding saline infusion, if upstairs can’t ground can use a bucket filled with salt water, and then put a copper wire in the water, a pick up in the machine.
5 large filled in the ink cartridges, ink system should maintain a 1/2 – about two-thirds, there should be no air bubbles in the refill tube, the new ink to head before installation should be equipped with 20 ml of ink, otherwise may cause the leak of ink.
6, backward and forward in the paper, can’t hold down a key forward or backward for too long, the buttons should be no more than 10 seconds, pause continue, otherwise it will cause a stepper motor or damage to the motherboard.
7, midway through the ink head operation, must be careful not to let the ink splashed in the motherboard inside the carriage, the ink head after reset, observe the carriage for a mesa, optic grating (especially) with and without pollution ink, if you have any ink spots should be set to clean up immediately.
8, should be regular cleaning filter ink residue in cylinder, in order to prevent precipitation into the pipe blockage and ink at the bottom of the head.
9, operating personnel to form the habit of doing operation log (especially when the shift), record the machine in different climate, temperature and humidity on the different paper material and all kinds of printing mode, and a variety of specific parameters for all kinds of printer files to print, summed up the best work experience.