The causes of white color alignment and color registration problems in uv flat panel printers

The causes of white color alignment and color registration problems in UV flat panel printers are non-vertical nozzle, height problem, physical location of both ends, poor nozzle status, software data parameter setting. The characteristics of the display are pattern leakage, image displacement and so on.

1, UV plate printer nozzle is not the vertical solution: check that the nozzle is not vertical, physical calibration under the position, make it maintain the vertical state;

2, UV printer plate height problem solution: the standard model of UV plate printer printing height in 10 cm, but 10 cm and 4 cm position print the same pattern, the effect is certain that the latter will be better. Do not scratch the nozzle under the premise, as far as possible to reduce the print height of the nozzle, so that the printed pattern effect is better;

3, UV plate printer at both ends of the physical position is not adjusted solution: manual adjustment of the physical position at both ends, so that the two ends of the upper and lower left and right completely in a horizontal line, open the printing control software, fine calibration can be;

4. A solution for the poor state of the nozzle of the UV flat plate printer: if the nozzle is in a bad status, it is necessary to press and wash the nozzle. When the ejected cleaning liquid is observed to be in the form of continuous water curtain, it means that the nozzle will return to a normal state and continue to print;
5. Uv plate printer software data adjustment solution: if the software runs too long and the data deposition is too much, there will be wrong instructions and printing errors.

At this time, a large amount of irrelevant data in the cache needs to be cleaned up. For example, after the data of the software setting is modified, contact the manufacturer and restore the original value.

It should be noted that: due to the daily maintenance of the operator may not be in place of the data UV plate printer software; it is inevitable to report errors, can be done in advance of the various software backup, numerical records, once there is a problem, re-installation can be.